Satellites currently use radio waves to exchange data. Now the data rate has been increased a hundredfold in two test satellites by using lasers instead of radio signals.
The tests between German satellite TerraSAR-X and US satellite NFIRE, covering more than 5000 kilometers in space without any errors, was special in that the space tests recently performed by Tesat-Spacecom was that the data was transmitted by laser.
The bandwidth achieved in the test was a hundred times greater than during conventional communication by radio waves, enabling a data rate equivalent to roughly 400 DVDs per hour. This could make it possible to transmit large data packets between several satellites in the future, for instance to send image data from Earth observation satellites to a ground station. That has not been possible until now, as the bandwidth of radio waves is not large enough. Another advantage of this new form of communication is that lasers are easier to focus than radio waves, which means that data transmissions can be directed more accurately.
The communication lasers on board the satellite are actuated by pump modules, which were developed to a large extent by researchers at the Fraunhofer Institute for Laser Technology ILT in Aachen on behalf of Tesat GmbH & Co. KG as part of a program financed by the German Aerospace Center (DLR).
“The modules have to withstand the vibrations and forces of acceleration on board the satellites during the launch and must then survive the inhospitable conditions in space – such as extreme radiation and strong temperature differences,” says Martin Traub, who led the developments at the ILT. “We therefore tested the pump modules under extreme conditions in advance, subjecting them to temperatures of -35°C to 60°C, acceleration forces 1300 times as strong as those of the Earth, and gamma rays.”
The modules mustn’t be too big or too heavy for use in space: Measuring 5 x 5 x 2 centimeters, they are barely larger than a matchbox, and weigh little more than a bar of chocolate at 130 grams.
“We achieved this minimal weight by selecting the right materials and a sophisticated housing: Any material that wasn’t absolutely essential was milled away,” says Traub. The major challenge is that, despite the reduced weight, the heat generated by the laser’s several-watt output still has to be dissipated.
